Recent content by Faz2726

BingoBongo, ha ha ha

Good god please stop reading google! maybe you should try and find a forum where you can ask questions about this matter! Then perhaps i can be a jobsworth. If i stuck to this 65 sec rule my job would never get done bearing in mind i do evaluations and trails! Anyhow, right time to use...

some of you guys really dont get it , why would i be asking on here if i was an expert on boilers ! your right just because of my job does not make me an expert in this area if you actually read the posts you would see that ! Why do you watch discovery channels then !!!!!!! if everyone...

you seem to be missing the point i was asking the question of why can it not be done?! it does not take a ' rocket scientist' to disconnect a gas pipe and reconnect and check for leaks , then pressure test it! It seems very easy for people to say you cant do it but im sorry i have slightly...

Cheers NIge finally someone has answered my question , instead of going 'they are surposed to be together' obviously not know exactly why! And for those that are worried i only took the fire off to clean, its all together now!!! Also thats the least of your worries i work with bombs and...

Firstly im not breaking the law 'compitant' is a very loose term! don't worry i know how to check for gas leaks! I am also aware that this boiler needs good ventilation , if i was to cover it over it would be in such away that it can still breathe and gain access. So if the gas pipe...

Right i am decorating the front room and am dying to get rid of the dated fire that is in front of the back boiler. Have done a lot of research and people say you cant remove the fire and just have the back boiler. My question is why ? I have removed the fire myself and its only a gas...

Hopefuly someone can help , bleedinbg the rad as there seems to be a bit of air tin the system, bubbling noises! Iv turn heating off first then bled the rads some seem to dribble others spray out at high speed , but does not seem to be any air. what is causing the high pressure should i...

not sure what to go for now 1/2 or 3/4 , i have measured the threaded portion on the mixer tap at 1 inch? will this do it ? http://www.twenga.co.uk/offer/5802/7986951584728756503.html

might be i just measured the diameter, so u reckon its 3/4?

As above i am after a 1 inch 25mm chrome stop end to cap off a shower on a mixer bath tap. Any help will be great Cheers Ben

well i think ill wait until the summer and give it a good blast and take all the rads off etc

Im after a block driveway , need to know what to look out for with contractors . New to the area so dont know who to ask for a good reference

dont know if these will help!

http://i95.photobucket.com/albums/l154/faz2726/DSC00662.jpg http://i95.photobucket.com/albums/l154/faz2726/DSC00663.jpg http://i95.photobucket.com/albums/l154/faz2726/DSC00665.jpg