Recent content by fitzpad

Thanks for the education guys and indeed the entertainment along the way. I am sure the sucker Ive ordered will come in handy for other lighting in the house and the screwdriver will be put into action when i get home from work today...will feedback when done. P.S. I didnt think I could...

all going over my head a it to be honest, but i'll try to remove/replace the bulb using a sucker and take it from there! Thanks for advice so far...

Thanks. Does your EDIT invalidate the 'sucker' requirement? i.e. is the sucker for removing the whole unit, but this may not be required if I manage to remove the lens?

Apologies for the very basic question, but... Ive moved into a house and cant figure out how to remove one of many bulbs in the kitchen, positioned under the wall units...any advise appreciated. Ive tried fiddling with it but nearly ripped my fingers to bits on the sharp edges...Ive...

It was indeed a fault door contact-thanks very much for the steer. good luck with getting your crystal ball sorted, although on that form i don't think you need it :)

No zone list unfortunately. i have door contacts on the front door and one other door (leading to the garage). I will check them both out - I presume these contacts are typically generic - i.e. i dont need a particular brand/type. Thanks for all the help so far...

OK, is that an educated hunch or is that specifically what happens with a faulty door contact? do you mean like a loose wire or misaligned contact? There are several door with contacts on them...is there any way i can test them individually?

sorry, yes, should've said...Whilst setting, Just zone 1 shows up as solid red, along with solid green Unset light....along with the beeps - all of which continues until i enter the code again.

hi there, new on the forum so apologies if missed any etiquette - although i did scan this forum before posting and couldn't see an obvious recent title...so here goes... moved into a house recently and having been given the code by the previous owner (must change it at some point!) I've been...