Recent content by gowdon

thanks for the feed back gents

on the compacts there is a flow restrictor on the inlet to the heat exchanger,i have a few cases where it gets restricted wirh debris slowing down the outlet flow to your hot taps

more info reg,is it a combi? y plan, s plan etc

Why is it on some vokera combis changing the dhw diaphragm is straight forward simply because its split,yet on others its because it seems to have overheated and melted inside the housing causing it to stretch and mis shape

I agree Ferroli are not that bad,not much repair work needed,personally more reliable than the baxi in my opinion

I would say that if its aparking ok then aps has proved ok,check inlet pressure?Is there voltage to the gas valve?If so suspect electronic failure from pcb

with the case off and the boiler fires up could be a few things!The aps could be at fault or the aps tubes blocked or cracked.Is the heatexchanger clean and all the flue ways clear?

Is the pressure gauge reading between 1 and 1.5 on the front of the boiler

The black taps either end of the chrome filling loop need to open before you can re pressurise your system