Recent content by ha007

Hi All Thanks again for all your input. There seems to be some confusion over what is needed, even to a layman like myself. I will call Corgi in and get it checked then post a reply accordingly. Hope this hasnt openend up a can of worms????? regards ha007

Thanks for the reply. If that is his bedside manner then no wonder he has the time to post such replies instead of being busy with customers. We, the general public put our trust in the experts. We only start to question when things go wrong. We all make mistakes from time to time but...

Firstly thanks for your input. IF you had read the posts you would see that I said he was Corgi registered as I do have the common sence to check these things first! I also resent your implication that homeowners want to have things done on the cheap. I take all transactions with builders...

thanks for the replies. asked him to go back. he wont. says its up to the manufacturer. If you were unable to ascertain the diameter of the pipe, what tests would you do to ensure the size pipe was correct if you could not see it. Would you connect to whats there or would you put in a new...

sorry, my 2nd post should have read' what written tests should i have had from him. all i have is the comissioning card

ps he is corgi registered

what should i do and what written tests should have had. :?:

Hi Hope someone can help. If a gas installer cannot see the size of pipe feeding a gas cooker in the kitchen but then runs a t off the 15mm pipe that is visible by only a few feet to install a new gas ch system, what should he do to make sure the pipe is the right size for the 2 feeds? Heres...

hi all thanks again for replying. all the info i am being given is from a local gas engineer. bit of a rough diamond but a neigbour in the same street reccomended him and apparently they had the same system and specs of pipe as i have. i'm up against the wall a bit here as he is the...

hi all thanks for the replies so quick specs are as follows... (meter is on front inside wall of lounge in built in cupboard) Distances.. 3ft from meter to gas fire in lounge then 30 ft run to kitchen boiler location. 40 ft in total to the cooker. 3 bends in total but what pipe is visible...

Hi Hope someone can help. I have a house which has the gas meter and supply in the lounge, front wall, and a gas fire in the same room. The supply then runs nearly 30ft under the floor to the kitchen at the rear which feeds a gas cooker. There is soon to be a gas CH system running 7 rads but no...