Recent content by Harry888888

Can anyone help I have just installed a towel rail in bathroom (swapped over from old radiator) I drained the sysyem and then refilled it. After refilling the Worscter 15/19 CBI bolier fires up for about 60 seconds then goes off - tried this numersous times and does exactly the same thing...

Yeah your right I am not sure where I have teed in I thought I was teeing in on the heating circuit flow & return like I have done before. Can anyone explian/advise the best place to tee into the flow and return. If I was to start this work again could anyone explain the best place to...

I have teed into the flow & return close to the cylinder cupboard which is close to the pump for the heating system. :cry: Any ideas: the boliler has been serviced regular, inhibitor is being used. Would it be better to tee in further down the system rather than clsoe to the pump. This...

I have tried closing down the other rads but this radiator still does not get warm. The garvity system & boiler is only about 6 years old. radiator size is 900 x 450 double convector. Could it be the position of where I have teed into the flow & return pipes close to the cylinder and pump...

I have a problem with a newly installed radiator. I installed a radiator downstairs in what was previously the garage. we have a gravity fed system, and I teed into the flow and return close to the cylinder cupboard, and reduced to 10mm (simialr to other radiators in the house) when I...