Mark,
Many thanks for all your help and patience. I wasn't going to let this beat me and finally found the problem today by again getting up the ladder in the bell box and finding a loose wire in the connector.
I then wired the panel up 'correctly' as per your advice and finally it works ...
In other words my alarm bell strobe and siren doesn't work if the connections are;
Strobe - to ST -
B - to s -
But it all DOES work correctly if I wire it
Strobe - to s -
B - to ST -
No I said originally;
When I wire it as above (correct way) the blue strobe permanently flashes on the siren box ((& the siren won't work)). I then swopped the two wires (incorrect way) and it works fine.
Hi
No wiring is spot on and no cross wires. Alarm has been wired the 'incorrect way' for 4 yrs & worked fine (siren goes off when alarm actuated & strobe flashes).
Can't understand how s - & st - wiring makes a difference what does s - do ?
Hi guys,
As advised I have wired my Accenta G4 alarm panel that has the following terminals;
Strobe + (not used)
Strobe -
T (SCB)
A (SCB)
D (Bell) +
B (Bell) -
To the AG6 siren that has the following terminals;
TR -
S -
V +
V -
ST -
I wired it as advised as follows:
Strobe - to ST -
T...
Hi guys,
Can you please help me ?
I have bought a second AG6 bell box to go on the rear of my house. I have a fully working AG6 on the front of the house wired up to my G4 Accenta alarm panel.
I only want to power the new rear alarm box to use the alternating flashing LED's only and not use...