Recent content by kellykyan

iv receintly done a rendering job which has gone completely wrong! first i sbr ed the brick then had two scratch coats 4.1.1 with 2days between coats prior to a top coat of 41/2 5.1.1 with waterproofer of 25/1,the gear floated and sponged very well with the plastering sand from wickes after...

which diff do you mean as iv taken the center diff off the jeep,

i have removed the dif/shaft that drives the rear wheels off a freelander as it was sounding quite rough and not needing 4x4 this time of year. amazing difference on fuel and doesn't sound as rough,was just wondering is this the wrong thing to be doing, any help appreciated

i have replaced the standard radio with a face-off cd player several days later the radio stoped workin-wouldnt turn on. so i then checked to see if theres was a live to the radio which there wearnt so iv run a live straight from battery to run the radio. the problem iv got is that theres a...

do these models require reprograming once replacing pump

common rail

vectra 2.0dti 2000-last week i stoped at a shop for 2mins and car wouldnt start since. iv had the car fault codes read saying faulty fuel injection pump,so purchased a 2nd hand one with exactly same numbers onit, still wont run, then noticed a sump full of deisel so then changed the four...

goodman

im due to screed my bathroom floor 75mm onto a concrete base, im wondering if im able to use just ordinary building sand instead of sharp sand as iv already got it here, will it still bond together in the same way.

how much sand and cement do i need for a scratch coat for around 60 mtrs, and how is this worked out

this all new to me

all plans and regs are sorted, who are bco?

im planning on building a small extenstion over a sewer in my garden, iv already entered the building over a sewer agreement which i have not sent back as yet because the pipe had collapst as i was digging around it and dnt want the inspector around until iv sorted it,the pipe is around 6mtrs...

thanks for your reply the outside has already been rendered few years ago and the rising damp has been treated too so i dont no where its coming from?

i have taken my kitchen wall back to brick and patched in with sand an cement in some parts due to water damage along time ago and lots of like fluffy salt on the surface. i have made the repair and skimmed the lot, 7days later theres still parts that still hasnt dryed out and lots of salt...