Recent content by krisssh

gas2air and johnmdc I read ur comments after I fixed the issue, yes you are right about the terminal 1&2. They are now separated. I fitted back the old thermostat but fixed to the back side of the wall with Max temperature. And it's original position fitted the new hive thermostat. Thanks all.

wiring centre is near the hot water cyclinder. btw with regards to the old thermostat wire, I connected the red and yellow together and blue one just taped it and pushed into the wall. I read on few thread that this cable at thermostat is obsolete, doe this mean I shouldn't connect the red and...

Original Programmer Wiring Hive Controller Wiring

hi all, Our boiler is Potterton Prima F, with EP3002 programmer. I replaced the programmer and thermostat with hive (http://www.johnlewis.com/hive-active-heating-hot-water-with-self-installation/p2965185) After the installation the system is working but the feed pump is always on and also the...

Hi Experts, I am after a switch for lights where it can turn on mutiple lights by pressing it mutiple times. Currently our lounge has four spot lights one per each conner and controlled by one single switch, which turns on all four. But I want to install a chandelier in the center and...

Yes, cable strain on the both the ends, one in the BC cap and another at the terminal. Its not my own flat, otherwise I would have fixed a ceiling rose. Cheers

He is the pic, how it looks now. thanks all, especially crafty and sb.

thanks for the info Chris, but I find those bulbs are expensive and when I move to new place, then these LE bulbs might not be of any use to me, and as spot lights are inside the ceiling they do not spread their brightness to the whole room, unlike when you hang a standard bulb in the center of...

All, thanks for your valuable input. SB I tried to open the spot light unit, and I feel the unit top/head is wider than the ceiling cut out, I may be wrong. But I unable to pull the full unit out. I am attaching some pics for your understanding. Also I think its not 12V bulbs...

Hi, I am a tenant, recently moved and the flat has a open kitchen plan with nearly 14 X 50Watts spot lights has 3 separate switches to control them. I am not tight but, I would like to save money and energy by removing all the bulbs and replacing the centre bulb (by using adapter) with a...