Recent content by KS

Hi, I couldn't see any movement in the switch when I turned it on (I tried turning off at the mains, turning back on, then turning on a tap - nothing happened!). The pump isn't moving at all from what I can see. Any other suggestions, or is it time to call in a pro? Best

Ah yes, I wasn't too sure what the 'system flow switch' was (is it perhaps the clear plastic, irregular shaped, box that sits above the main control pcb?) so wasn't able to check if the pin was moving. There was no movement that I could detect in the box I mention above (which the manual calls a...

Apologies all - internet went down yesterday as well so I only just got the new messages. Many thanks for all the help so far. In answer to 'diy's' q: the pressure is at 2 Bars when cold. Tony, many thanks - I unscrewed the screw on the front of the pump, spun the internal screw, but...

This sounds serious! Boiler is only a few years old so it seems odd that the pump has gone. Is there someway I can check? Thanks

Hi All, Sorry, I had missed Dave's post - many thanks for the advice. I have drained off some water (now reading 2 bars - is that sufficient?) and have located the fault codes. There is this combination: 1st Light (green): FLASHING 2nd Light (red): ON 3rd Light (orange): OFF From the...

I am afraid that I can't figure out the fault from this, the manual indicates (although I could have missed something) - the fast flashing, according to the manual, indicates a 'fault' - but it doesn't specify. There are some codes but these are from a series of three LED's and I only have two...

Hi Mick, No noises really, just a attempt to start up, then fast flashing of the green LED. There is no pilot light either. I have tried the reset button, but to no avail I am afraid. I was being hopeful re: the pressure, it has been high before and worked fine, although not as high as 2.5...

Hi All, Typically, on Christmas day my boiler decides to pack up! It is an Ideal Mini S24, and appeared to be running ok with both CH and HW. It was running a little high on pressure about 2 bars, and I think the valve had been left open as it has gone up to 2.5 bars. Could this have caused it...

Would anyone have any pointers for fitting a new kitchen, I am thinking of replacing the one in place at the moment (a very small kitchen!) - it will basically only get a sink housing, corner unit and oven into the space. Just want to get an idea of what might be involved before I go ahead with...

Hi, can anyone give me a few pointers as to the best way to figure out if a wall is load-bearing or not please? I am thinking of knocking through a doorway into a large area under a stair case in a 10year old house, I am pretty sure it is not loadbearing as it is a very short lenght of wall...