Sorry it's a Worcester 28si II and the thermostat is a Dayton Digistat 1. I've just taken some pictures of the set up so will try to upload them if I can work out how to do it off an iPad!
I have a Worcester Combi boiler and over the past few months I have had maybe 5 incidents of the heating not working. The pilot light fires up and works fine for hot water but when I click advance on the heating nothing happens. Within a few hours or overnight this usually goes away but it's...
Hi,
I've recently had an internal door dipped and stripped and have purchased some new door furniture to fit. Unfortunately the door has a large hole in it where the previous latch was fitted. The latch I have purchased and want to fit is much smaller so wanted some advice on how to fill the...
The waste water pipe just flows out into the outside drain I think - the wall you can see at the back is an outside wall.
No plumber in the family but I do know a couple.
I think I might try and build a sturdy table of some sort and screw it down to the table so that the waste pipe is at...
Here is a picture zipper - I too didn't think it would work when I first tried it but its a new house (to us) and we've only been here 6 weeks. The previous owner had his washing machine on a table that raised the height to near to the ceiling but the table was very unstable when it spun so I...
Hello,
I have a Bosch Washing Machine that is fitted in the cellar. The U Bend is at ground level which is actually near the roof of the cellar - this means that the waste pipe is connected to the U-Bend vertically. Its about 4ft from where it comes out of the washing machine to where it fits...