i have just tried to put zone 1 into program 1 but got the same negative beep
Prog
Engineers code
Prog
1 (program 1)
3 ( time inhinit zones)
1 (zone 1)
i then get the negative beep, because, I'm assuming, there is no zone 1.
Hi,
The procedure I'm following is -
Prog
Engineers code
5
1 (zone 1)
1 (security)
reset,reset,reset.
the tone i get after doing this I can only describe as a negative tone
I cant see why it doesn't let me reinstate the zone?
Hi All,
I have an accenta g3 mini fitted in my house. I disabled the front and back doors so we could have new doors fitted. i followed the instructions in the engineers manual but i cant re enable these zones using the same procedure.
Is there something else i need to do to get these...
Hi,
I currently have 2 seperate light switches side by side. One for the front room and one for the stairs.
I want to install one double switch and make the hole good.
Can i wire 2 seperate light circuits into one switch?
thanks
Matt