Recent content by leonjudge

Thank you . I think i will try and use some sort of filler piece and bring the unit forward.. It's 305mm deep, the previous was 500mm. Would you just build the filler piece or is there something you can buy to do this?

Good evening I have recently stripped my en-suite pending a full refurb. I produced a design and have ordered units / shower etc. Upon removing the old vanity this morning I found that there is a cut into the en-suite from the stairway which is immediately below the en-suite. The old vanity...

Thanks for all the replies, much appreciated. If guess they will continue to spray it until it either doesn't start up again, or the noise is so bad that it wouldn't be acceptable - it's a shame he didn't have one on the van! :-) He definitely used wd40, and then used something in a...

Evening all I have a glow worm boiler which stopped working the other evening, I have a British Gas Homecare contract so called them out. They arrived the next day and spent a good 20 minutes or so spraying with WD40 and something else I didn't recognise. It still didn't start. I saw the...

Thanks, yes ex ADT system. I intend to run a separate cable to the panel so if the panel has sufficient power (not sure how I would work that out?) could I wire that into the same terminals to where the internal siren is connected, adding the strobe. Worse case I could disconnect the...

Hi I have a galaxy 2 system with no external bell, just a dummy box. There is however an internal siren with battery backup. This is wired to the SAB connections on the panel, all connections used but strobe. If I want to add an external bell, can I wire it in parallel to the internal...

Thank you - will give that a go. Are the motors specific types for different units, these are danfoss?

And finally - the pump was replaced about 3 months ago after it failed - just in case it could be linked?

There are two of those in the airing cupboard (the boiler is in the kitchen) and both are set as auto. One of them moves to manual (with a bit of give) and then sets back to auto and the other is loose to about 3/4 of the way to manual and then does the same. Does that help? Update...

Thanks - I have taken the danfoss timer off the connection block which is screwed to the wall. With the FCU switched on the boiler still starts so I assume that rules the danfoss timer out?

I have a gloworm 40ff boiler, danfoss fp715 HW/CH timer, and a Honeywell cm907 programmable thermostat. This morning the temperature was set at 21, on the Honeywell unit, however the temperature managed to get to 25 degrees - the boiler was running constantly. The normal setting on...

Thank you both for the replies - will get some wood. Leon

Hi There is a driveway to the side of our house which is used by the neighbours to gain access to their garage(s). There is a pipe on our wall which has a wire cage protecting it. The pipe looks like it could be an overflow/outlet from the water tank as the airing cupboard is above from...

Overflow Pipe