Hmmm, thanks for that thought.
Before I rush out and by a new momobloc tap, is it feasable to disconnect the connecting studs and repack the threaded hole with sealant before re-inserting the studs :?: :?
Just an :idea:
Thanks for your help.
I have a similar problem but the leak appears to be coming from the connecting studs that hold the tap to the basin.
Initially I assumed the leak was from the 10mm flexi tails but reassembling them (after checking for damaged o-rings) I ruled this out.
But I could be mistaken?
The leak...
Thanks for response Guys.
(1) There is no tank;
(2) The Vokera combi (Excell 80SP) has a 23.7kw max heating output. The thermostatic valves specifications confirm that it is (a) suitable for unequal pressure; (b) minimum of 1 bar and maximum of 5 bar pressure operation and (c) suitable...
Question: the original bath cold water supply (mains pressure) is 22mm but the hot water supply is 15mm should both be 15mm or both 22mm :?: If not why not - balance/flow issues :?:
I have a Vokera combi boiler.
I'm intending to fit a "Hudson" type thermostatic valve (wall mounted) to...
Many thanks - spot on!
Quite a lot of "debris" had accumulated preventing the assembly from being extracted.
Will pay attention to this in future :oops:
Now all fixed - again, grateful for your input. 8)
Our W/M stopped emptying and spinning.
I've managed to download the manual for the AEG Lavamat 74335 W/M.
The diagram doesn't make it clear when accessing the filter/pump (lower right front of W/M) whether only the cover screws off or whether more of the assembly should be extracted from...