Recent content by mmalone

im looking for a little help with my microwave, just cooked as normal and now when i close door the fan/ turntable and light stays on, its not cooking tho just staying on , tried removing plug and leaving out but its like its jammed on, if i set timer etc it cooks as normal just when it...

mind if you bleed your radiators you'll need to repressurise again !

job done, used the rest of the rods and worm hook to go thru other drain and push round corner then took plunger off at manhole and pulled rods thru !!

andy yes 4" plunger on and no rod breakage , just gonna attempt again today

got a problem with my drain rods ! plastic drain runs under house and from first rodding point all went well on a straight run back of house to front drain, then i put rods in at side of house next to my utility room in house as sink had occasionally blocked rods and plunger got half way down...

pcb was the problem !!!

guys, got a vokera option playing up, had a thermister problem which was sorted tonight. fired up no probs all ok, then i put casing etc back together and solid red light fault came up once i restarted ? flashing red is thermisters etc, so doen all the checks, fan and pump runs and as soon as...

tony as much as i agree with the one off thing,ive had problems with other suppliers before but always sorted quickly, ive emailed on several occasions and not even had a reply... very poor for any company and for me as a first time buyer from this place..... it will be my last dealings with...

cheers mate!! wouldnt ever touch this mob again, absolute joke of a company, if i was local i'd go in and pull the customer services guy over the counter...

just a note for anyone who uses or had seen them on the internet !! DO NOT USE !! Ordered a pcb 2 weeks ago, they debited the money and no pcb arrived , called them they advised it was obsolete so money would be reunded. was unhappy as no phone call or mail to advise and i paid for next...

pannierstan, you still got it mate ??? email address is above , need to know by monday latest as I need for wednesday !! cheers

buzzing noise is the sticking relay on the board, very annoying but can be lived with for now . no hot water is a most likely a faulty blender valve, something you cant live without !!!

pretty sure there are 2 relay pcb's on this model, may be wrong but had the same fault on a gledhill, is the buzzing like an alarm clock ?? if it is this is the fault I had, hard to test the pcb's though !! you may need to replace both.. approx 40 - 50 quid each though !! most common to go...

as DP says, i'd try this before anything else especially the venturi, take it out and clean thouroughly, blowing is not enough...

hi mate, would be very gratefull, quite happy to give you a few quid for it or may have something your looking for, got a few old parts in the loft myself .. email me at [email protected] and we can sort out asap !! cant pm you for some reason ???