Yeah it seems to drain fine with no problems.
Im just working with what was in place already and trying to improve it along the way. Its a converted building which was done back in 2003 i believe.
Don't know if the building regs applied then or if they did, how they managed to get it...
Evening all,
I have a wet room that is currently being fitted out as a replacement for a badly fitted one. I havent moved any of the furniture around (ie the toilet and sink), just updated them slightly.
I was just browsing around last night and came across the building regs for plumbing...
Okay thanks guys, ill go into City and ask for some to save mistakes.
Back to the double check valves, I get what you mean about those. Where abouts would they need to be fitted, and is it on the hot and cold feeds?
Happyplumber,
I dont think ill have enough room there to operate the handle. Would this be okay for the smaller space?
http://www.screwfix.com/prods/76597/Plumbing/Brassware/Comap-Full-Bore-Isolating-Valve-Chrome-15mm
Cheers,
Pete
Cheers for the comments so far chaps.
Muggles...
The shower head is only there at the moment because I was testing the fitting in the elbow. I have already drilled a hole in the backboard ready to go :)
There is going to be a slider rail fitting on the other side there to right. I...
Cheers Andy,
There is a main bathroom on the other side of the wall, (waiting to be re-done too). There will be an access panel from other side of the stud wall there so I should be able to get at the isolators from there.
I have also fitted a Top Dec tray with a built in waste which...
Hello,
I'm installing a new wet room. Just at the stage now of finishing the walls. I have completed all the plumbing and its been in place for a few months now. Everything works nicely with no leaks etc.
Can anyone see any issues with what I have installed? (See pic below)...
Matthew,
Cheers for the reply. Its a stud wall and I have fitted a horizontal noggin with a wall plate elbow like the one below:
http://www.screwfix.com/prods/44390/Plumbing/Compression-Fittings/Conex-Wallplate-Elbow-403WL-15mm-x
My problem now is getting a good enough seal for where...
Hello All,
I am in the process of fitting out a wet room. Just going to start the plumbing for the basin hot and cold water.
There is bit of an awkward pipe run that i need to do. Before the floor goes down completely, what's the best way to sort this?
I need to bear in mind that it...