Recent content by networkrail

Well explain to me the definition of competence Dan. You've no idea of my background or competence. I'll give you a good start, one of the main factors of competence is knowing when to ask for help, and that's what I've done here by posting this thread. P.s you don't legally need to...

Where in the legislation does it say that? I'm sure it states competent person not gas registered engineer!

Thank you for your reply Julie. Unfortunately I own the house so there's no one who can fix it for me without it costing a fortune. I've got an air pressure switch on its way, think I'll buy a new fan too. NWR

Morning all, I'm having problems with my Micron 40FF, it's around 7 years old. Back in December the fan went, I replaced this and all was fine. But then in April this year it started playing up again, it would work in the morning but midday to the next morning the boiler had two...

Hi All, I'm having problems with my hot water system, I'm getting CH but no hot water, when I say no hot water what I mean is there is no pressure on the hot water at all, when I run the hot water tap it runs for about 10 seconds and then starts to stop until nothing, then I have to water at...

a glow worm space saver kfb 40

Hi chaps my boiler is broke i asked how much for a new comby to be fitted and the price i got with a 3yr warrenty £1200 is this a good price? Networkrail ________________________________ Lynda, moderator please note forum rule 9

Hi all wonder if you can help me my heating broke yesterday and it was just clicking so today i had a look and the pcb had burnt out one of the tracks had burnt out. can i solder a strap from one side of the circuit at the first contact to the other end of the track contact to make the curcuit...

How about a timer on your plug?

How can i find out the sites for my area? runcorn cheshire

Yes but what if they stopped all mail then not just junk

Thankyou Sime10,Bamber gaspipe all rads are working hot at top bad bottom working a treat thanks to all. What a great forum

yes done that and the others seem to be getting warm now. iv got a sun vic motorised valve but think its nakered have to turn the valve with a ajustable spanner. whey would it stay cold at the bottom but hot at the top? i thought if it had air lock it would be hot at the bottom but cold at the top.

iv turned the lock valves down upstairs on the rads. now the rads are getting warm down stairs but the tops of the rads are getting warm but the bottoms are cold is this air lock? do they need bleading?

The rads have got a thermostat on so i turn the teromstats off or the valve on the otherside if the rads? do they need balancing. The pump is working i think its hot also its on the fastest setting.