Hi,
From what i've read on here, the problem I have is that the motorised valve which controls where the hot water goes (tank or rads) is broken.
While I try and sort out if I can fix it myself :shock:
Can i turn off the boiler completely, and use the immersion heater? Will the hot...
Bit late - but I don't want to be kept awake with worry!
I have fitted two new valves for a towel radiator as i'm doing up my bathroom - the radiator is not connected yet though (it's not even delivered yet!). So the valves are both off.
The problem is, one of the valves seems to not be...
Hi, thanks to all for the clarification
It was also my 'assumption' that if it was twin and earth it would be a live feed.
The stat is a Sopac?
Looking at the wiring now - on the inside of the case there is a wiring diagram
As it is wired - Red is connected to 3
Black is connected...
Update:
got around to viewing the wires in the current thermostat
it just has normal twin and earth - red/black/earth
What kind of replacement will work with that?
thanks
It's one of those dodgy Potterton boilers that everyone on the internet says keeps breaking!
Not a combi
As an aside - the whole system needs a bit of an MOT. What else would you suggest is a DIY job?
Clean it?
Add some of that treatment?
Balance the system (some Rads aren't very hot)...
thanks for all the replies
I agree, wireless not needed - I don't think...the thermostat is already there and wired in, so might as well use that?
Will have a look at the wiring into the current stat, and take it from there.
thanks for the quick reply
so in order to proceed, what do I need to check with my current system?
Have a look at the room thermostat - check the wiring - what am I looking for?
When you say 'either' - what do you mean. I only want to replace the thermostat in the room.
I'm assuming...
Hi,
I'm trying to improve our new home's central heating, and have been recommended by a work colleague to get a Programmable Room Thermostat. I don't quite understand all the terminology, so i have a few questions;
Can i just replace my old mechanical thermostat with anything?
What does...
airlocks in the pipes - how do you bleed those?
would that be on the FAQ?
i've bled the Rads.
Why would an airlock stop the boiler coming on during 'auto', but not during 'constant'?
an update
left the CH on all night - dropped the temp to 16 so it wouldn't be too hot/cold
problem - woke up - felt cold :cry: - rads not warm
Checked boiler - it had locked out, pressed reset, CH back on again
Still the same with the timer obviously
What's going on?