Recent content by Pattrickk

can't I just use my hands like others have said? 17quids fairly expensive for something I'd use once and then it'd take up room?

I've got a feeling its been like this since the previous owners. Got a pair of gloves on order should come Thursday and I'll get stuck in (lucky me!) Thanks a lot for the reply, definitely put my mind at ease.

what does that mean? I was a bit worried before but now I'm petrified :/

[/url] there's one manhole but its further into my garden. But the toilet and bathroom all drain fine. Here's more pictures http://imgur.com/a/3AvlC I think I understood some of what you said and will look into it, sounds like its gonna be a messy, dirty, smelly job. Once its done though do...

Hi there, so firstly if I wanted to know more about my drainage system what would I search for? Here's some pictures (at the top you can press for more images) http://imgur.com/Q2j6fYK,pmfZBSB,ZWozDaG,zZVOFMR,K5TzSo2 The kitchen sink/washing machine and also gutter runs to it. The reason...

Seems to have worked on the hot still a slow drip on the cold, maybe I've just not been using enough PTFE this whole time? Will see how it goes once its redone and left overnight. At least I've replaced the flexis now though. Thanks for everyone's help

right, just got home gonna take it apart and give it another go. Thanks a lot for the help I cant express my appreciation enough! Will let you know how I get on.

its definitely from both 3/4 ends. I'll remove the PTFE from the 15mm (I only put it there as once this is in access isn't gonna be easy) and rewrap the 3/4 this evening and get back how that goes. How thick should I be doing the ends roughly? Thanks so much for any help or assistance. Wish I...

Still no luck. I'm going mad. So I've put a 3/4inch to 15mm coupler in both now with PTFE and they're still dripping. What am I doing wrong?!? Does anyone know where I can get any information on these diverters

Hence me asking what the right stuff is? I've found some 3/4" x 15mm couplers. Hopefully thatll do the trick with some PTFE in the 3/4 end and rigid plumbing for the rest.

So I think what I'll do is remove the existing plumbing including the nipples as I don't think they're sitting right. Get two 22mm straight couplers and remove the but and olive off one end, screw it into the diverter with PTFE, then run connect some 22mm piping and then two 22mm to 15mm...

Currently I've only got a 22mm nipple into the diverter And then the flexihose is 15mm to 3/4. So I guess I'll have to replace the flexihose with 15mm rigid and then do I find a 15mm to 3/4 piece and attach that to the nipple. Or is there something to put the 15mm pipe directly into the female...

Actually how do I even put rigid 22mm into a female inlet?

it is mains yes. So you recommend getting a 15mm to 22mm reducer for both, but use it the other way round and then attatch it into the diverter. How do I go about actually attaching the 22mm pipe to the diverter do I just need to get a nut and olive? If so that's pretty straightforward.