Recent content by pault140852

Hi anyone know if you can get these in 3". I am trying to get a vent up through the rafters which is not quite 45 deg. No room for 4". Tried googling but not come up with anything.

If it was me, I would upgrade the size of the hall radiator to achieve a comfortable temperature there. Fit 2 lockshields on it and put the room stat in the hall.

Asked to fit W/Bosch 24ri (client supplied) in place of Kingisher2 Mf with gravity H/W on C-plan with single combined cold feed/vent on primary flow @ cylinder. Not possible to run new primaries due to laminate floor, so looking for solutions to convert to fully pumped. 1. Simple solution...

Bump !! Apologies if this is not the right place to post this question. PS. I am gas safe Reg, - just more into plumbing & heating installation than boiler servicing ! Any help gratefully received. Paul

I am an installer, who has been asked to repair a friends boiler. Initially, primary flow pin on diverter wasn't lifting & APS wasn't making, so changed diaphragm & APS, followed by complete diverter valve, only to discover that despite the pump rotor spinning (and heat being dissipated), the...