Recent content by pd1971

Hi Dishman Have a look at the Drayton Mitime programmers with wireless room stat - which solved my problem, I picked the T720R on ebay for £45.00. I had a similar issue with a radiator in our hallwall that had to be left off, as the room stat was in the hallway, causing the lounge & the...

Dan...... It wasn't aimed at other installers, plumbers just the installer that fitted the boiler, it was just a rant....

Thanks but the installer was supposed to be professional, cannot trust them, shall only use a for Boiler servicing only, that way I know it's been done correctly by myself Had to purchase the Fernox flushing adapter as the elbows were too big to fit one side by side Have now cleaned the...

I had the TF1 installed from when the I had the boiler installed 3 years ago but have been having problems with kettling & have had to add 3 different lots of x800 to get the system clean The system was power flushed including the magnacleanse which the installer used, I'm not convinced that...

Finally picked up the Magnacleanse, it appears to have 3/4" & 1" BSP fittings 3/4" 1" The Fernox TF1 uses 1" fitting so I have ordered 2x 1 Inch BSP Brass Male x Female Elbows to connect to the TF1 isolators Will update the post when I have the Elbows to confirm that it fits

Thanks Rich, is there another way of connecting it without one of those (i.e. elbows, hoses, reducers) as they are about £65 Adey state they can work alone without a powerflush, simply closing of each rad in turn & using the VibraClean, have watched a few vids doing this without a powerflush

Thanks..... it's a Magnacleanse not a Magnaclean

Hi Just managed to get a Magnacleanse complete kit 2nd hand which I collect tomorrow I have a TF1 22mm installed & want to connect the Magnacleanse via the TF1 isolator valves Please could you advise how I could connect this up as I’ll need to buy some extra bits to connect is up, I...

Hi Have now filled the system & added x800 left for a 3 days cleaning out the TF1 at the same time Drained the system & flushed through & refilled & ran the system for 4 days with just water Drained the system & took off all the rads & flushed them through with a hose until clear...

Thank you so much........ that's really helpful :)

Should the surfaces be smeared & seals or just the seals? Would this grease do the job? http://tinyurl.com/lj3b4ok Many thanks

Hi Having issues with a 3 year old Wilo pump sticking, probably due to sludge as I'm currently cleaning the system out with X800, then changing the pump to a new Grundfos when completely clean Just want the pump to run for a few more days before I change it If I take the pump apart &...

Taken from the sentinel website

Many thanks I do appreciate your advice I live in a very hard water area would it not help, long term to put x200 in or is it wasted?

FYI https://www.youtube.com/watch?v=AAZhPYkYUE8