Recent content by peter the plumber

Thanks for reply. It's underpowered and a bit smoking. Is most if the work from top or is it easier from underneath. Can see most bits to get to. Thanks

Hi after some help please. Have had my car in to fords for glowing glowplug light. They have come back with seized turbo. Could someone please tell me how easy or hard to change. Thanks peter

Thanks for all your help will get anew belt. I will let you all know the out come. Once again thanks for your help pete

No I can't see any markings I am going to get a new belt Monday.If I put the newbelt on and is still the same will it cause any more damage. The van drives the same. As before but just a little louder though thanks pete

Yes it's that set up I can see cam marking. I havetaken crankshaft pulley off but not sure of markings. Is there a mark for pump as well thanks for your help

Hi I wonder if you can help me.last week my aux belt frayed and I changed it ok. Today went to start van and would turn over a bit then stop. Thought battery was dead bumped started it an now a knocking noise from engine I think timing has jumped as in amongst timing belt are strands of aux...

Hi help needed. Have wired up a s plan on to rebadged glow worm flexi com by British gas. The problem is that the boiler fires up even if programmer is on or off. The cylinder stat works and room stat works but programmer has no effect Have used a Honeywell wiring centre and boiler has pump...

hi i have a problem with the centrall locking.i press the lock button and indicators flash but doors do not lock.I have replaced the battery in fob and tried to syc,turned ign on for 30 secs then tried to press lock button but no joy. Could it be a blown fuse or faulty relay.I have looked in...

most likley the dhw heat exchnger.Is it the the turbo max with green buttons.These do block up and it will effect the hot water,its quite a easy job to do if you are pretty handy peter

If its so easy get registered then whats the problem then ?????

if its not so hard sit your exams, pay your money,pay your public liabilty,buy and run a van ,fga calibration and everything else to be legall.Other rgi have to do this to provide a safe and legall service .Then once you have done all this and people try to fit boilers and gas work ilegally you...

jack pike there is a brain surgeon that lives down my road i know and i was going to ask if i do some of his surgery and he can just pop along when i have finished and tell me its ok.These governing bodies are there for a reason to stop illegall work.I sat my acs and appliances paid my fees...

the water throttle at the bottom of the 3 way and change the clappet valve,this is under 3 way and pushes up on 3 way peter

as before pcb common fault on these

hi where abouts are u i can let u have pump ,pcb ,3 way clappet new thermisters and any other parts near enough all to rebuild boiler