Recent content by pinzy

The OP did say 2am-5am! Is this a fault with the programmer?

Thanks for your suggestion and Yes I would leave to an expert...not ready to die yet :D I say it's 10mm as that's what's written on the cert which the EB did. Visually, it is a monster of a cable close up and a bugger to bend. Maybe I can take a picture at the weekend but quite sure we...

It is a 40A Type B Switched MCB.

Thank you! How do I check MCB size?

one more to the left...

Ban, Steve, PoD, Thanks for all your responses. I hope this helps I have the certificate the elec board signed off when the shower was being installed but haven't had any further checks.

I have the main Consumer Unit with RCD protection and the the shower MCB is separate as there weren't any spare blocks. Yes it is a plug-in type of fuse.

Hi there, 10 years ago we had a 10KW shower installed using 10mm cable with a switched 40A MCB (Wylex). The installation was signed off by elec. board. I'm in the process of replacing with 9.8KW Mira Azora. 1) Now, am I ok leaving the 40A fuse with a new 9.8KW shower? (The ratings on new...

Having drawn and stared at the current wiring for days ( :shock: ) I think that actually makes sense to me :) It doesn't have the 3 amp fuse anywhere so that will be my first port of call! Thank you guys for taking the time to give advice I really appreciate it.

Actually something just struck me (lost a couple of brain cells last night!!) ...I can currently switch my CH and HW independently but the EP2000 doesn't allow me to set On/Off times independently....sorry I didn't clarify this earlier. I am assuming then my system is ok and does just need a...

:( well thanks for that piece of vital info.

ahh didn't know that. I do have a gravity system I think - boiler downstairs and hot water cylinder upstairs in loft. There is a pump for CH with 2 zone valves. Does that mean I'll never be able to have CH and HW independent without replumbing?

does the ep2002 allow me to set CH and HW independently? I can always sell the Honeywell on eBay!!

Thanks again. I was confused as the earth wire from the room stat was connected to the Live and I have never seen that - but it makes sense. Well it's too cold to attempt the change so I will wait for some warmer weather! If anyone comes across a wiring diagram for the EP2000 I would...

Thanks bab...another question...I have typical Blue, Brown and Earth wires coming out of the Room thermostat and Cyl. Stat yet in the diagram I see 1,2,3 and 1,2,C. Which one would map to L, N and Earth? Many thanks for your responses so far:)