Recent content by rijmrijm

ok, but i've seen flues that are 'multifit', what are these for??

hello all, is it possible to use a different make flue for a condensing boiler? eg. if i had a biasi condensing boiler, could a potterton (or any other make) condensing flue be used? are condensing boiler flues interchangeable? the manufacturers will say use only their flues, but all they...

tried all this, but nowhere to be seen, shall i contact bosch??

hello all, i am looking for a manual for a bosch sms4472gb/20 dishwasher. i need to test one of these but cannot without the manual... thanks

if anyone can answer this: i take it vertical kits are for going through roofs, plume kit can be used vertically but not through a roof. is this correct.?? i would appreciate it...

the neighbours garage is not a games room/gym as mine is, so any fumes would not disturb him. also, i have just enough space for a bracket to hold the plume kit on the side of my garage...i think it can be secured ok, just want to know if it is possible to do?? is this not ok??

my boiler is ariston microgenus 24...condensing..

i dont want to take the flue horizontally either way as the run is too long, and ariston are saying the flue should be angled upwards slightly. my gas guy says through the roof, but if i did take it through the existing hole, and then the elbow and then up, do i need a vertical flue kit, or a...

hello all, i need help!!! i have a large brick garage at the end of my garden, and so does my neighbour. the gap between our garages is about 400mm. i have a boiler - ariston microgenus (rubbish i know!!) in my garage, and i want to pass the flue out of my wall, then an elbow up and then a...