Recent content by SADavids

I'll see if I can match it tonight, but I'm not that convinced by pictures anyway. Sadly I have nothing on the cylinder, I reckon the apartment was 10 years old when I bought it. No manual, docs, installation papers - zilch. Apparently OSO will respond in 24hrs, still waiting :)...

Yeh, I've sent an email directly to OSO Hotwater, hopefully they can send someone around. Alternatively I might ask the building management if anyone else has the same problem and what they did to fix it. I have no instructions, no installation details and I don't think they even make my...

Actually I managed to find a sticker on the side of the cylinder, there's a number I can ring. Hmmm yeh, maybe I need to have it serviced. I thought if it's a minor problem I can fix it myself but it's been a while since anyone looked at the thing - it's wise to have it looked at. Does...

Hi, thanks for the response. My cylinder is a: OSO Hotwater, Direct Unvented Water Heater. Not quite a boiler (I don't think?) as my flat has storage heating. The sputtering only occurs with the hot water tap, cold is fine. Not entirely sure what a cold water cistern is but I presume...

Hi, I couldn't find anything relating to a sputtering hot water tap, thought I'd start a new topic for advice. From what I can understand it's probably air in the hot water tank. I live in a flat on the third floor (not sure how relevant that is!), about a week or two ago the bathroom sink...

UPDATE: Firstly I must thank a member of this forum who offered us indispensable advice. Mikefromlondon thanks for looking after us! I finally managed to get my mate's brother (a certified plumber) look at the problem too. Apparently it's the 'Flow Centre/Thermostat'. Strangely Dad said he...

I didn't imagine my Christmas would be so stressful. I found the phone number of the local plumber who came last time, and he's given me a rundown of the entire situation, a lot of details my old man didn't tell me. It's ridiculous to be honest because to cut a story short, we've been using...

Aye, he paid. Bet it was the cheapest plumber he could find? Or he told the plumber to do it at the cheapest price?

Installed a lovely new £30 hose from B&Q. The old one was actually taped at both ends! I ran the shower and we tested the hot water pipe behind it, the temperature fluctuated on the pipe. That means it's the Plate heat exchanger right? During the test my Dad said his Eon Central...

Is the pipework badly done? I do wonder because my Dad's a bit of a tightwad, he probably got it done as cheaply as possible... Is it worth getting an electric one installed? I'm thinking long-term.

Thank you! I'll get a new hose first. Then I'll do the testing with the tap. I don't think my Dad understood much when the engineers came, I don't live here anymore, so I'm trying to fix this before I leave again. I will let you know how it goes. Thanks again.

Yeh, I'll make a trip to B&Q sometime to buy them a new hose! As for the problem - is it likely two engineers from Eon didn't diagnose our problem properly? The plumber said it's the boiler, they say it's the shower. :(

Hi, I'm literally ripping my hair out of frustration, not good on Christmas Eve :( The shower at my parents isn't working properly, the hot water tap fluctuates between hot to cold (utterly frustrating because the whole family is back for Christmas). I thought my old man was sorting it but...

I only repaired them once, this was the first time the bulb went out - forcing me to look inside and spot the burnt terminal block :( The previous owner was a student and didn't really bother, I bought the place with half the spotlights not working, luckily all except two were just the bulb.

Erm.......... I knew that :roll: Least I'm learning something new!