Recent content by sheep

Hi Guys, I ve had a B&Q toilet for a while now, say at least 5 months. I've noticed that over the last few weeks it's starting to take longer and longer to stop after a flush. It over runs down the centre flush tube. At the left hand side where the water come in I have a tube with an...

Nope only a compression straight fitting and copper pipe with a bend to the flexi hose.

Yes there is flexi's installed. These were like this with the previous sink and bath and was a better flow.

Things again for your response, could there be anything else I can try to improve the flow from the 0.5 tap?

Hi mate, thanks for your reply. I can look to change the bath but will this improve the sink on another 15mm tee. I was thinking to install the grundfos upa 15-90n on the outlet side of the water cylinder. Cheers

Hi, Yes the bath supplies tee off the 22mm supply on to 15mm for both hot and cold feeds. Cold is on mains and no problem at all, all over the house. I am thinking perhaps I need a pump to boost the use of the taps then for hot supply in bathroom. Cheers

Hi, I am writing for some help and advice after recently installing a bathroom upstairs. I have a 3 bedroom house with a gravity fed header tank in the loft feeding the hot water cylinder positioned upstairs, that then feeds my bathroom upstairs and my downstairs toilet and kitchen...

Hi Guys, I have a Worchester 24RI Boiler, it failed on me the other day and the fault was down to the main pump for CH and HW. This was replaced and now all is fine. One thing that I have now noticed, that when i put on the heating, the boiler takes ages to fire up, nothing happens for...

Hi mate, that explains it then. By adding this wedge they have a permanent live to the boiler and the pump running (blue light on) as soon as as i remove the wedge it switches off and only works from the timer on the wall. I best get it checked over. Thanks so much.

Is working properly - meaning the boiler switches off, blue light included, and only comes on, blue light followed by green when the 2 way valve is opened. If that is what it should be like, I will remove the wedge :-) Cheers!

Thats what i am thinking, But would like to ensure is not for a specific reason.

Hi guys, i have recently moved into a new home, the last owner had a new Worchester Bosch 24RI condensing boiler installed last year. Since moving in i have always, noticed the constant sounding of the main pump that is controlled off the 2 way valves (HW + CH) Today i decided to have a...

I notice when i was under the floor boards that one of the radiator pipes that has been bent in position has a like a crease/kink on it. As if its been bent into position then bent back again to allign. Its a small crease sticking up about 1 mm on the bend. Can this be a potential week...

Guy's I know your not suppose to touch gas, but can you disconnect your hob? I have valve at the bottom of the pipe at the back. which if i close the valve the hob is isolated I've tried and tested. I just dont know if i should disconnect from the valve or call in a corgi plumber to...

Hi, pressure i was meaning that the pressure within the main 22mm pipe, supply from boiler, that my 15mm pipe is connected into for the return side of the radiator was greater than the radiator pressure being returned. Meaning that its not flowing