Recent content by southcoaststeve

Nope, i drilled roughly 20 holes from the window ledge to the floor in a vertical line at each end of my opening, then removed the remaining section with an SDS on chisel mode roughly 6" deep at a time, this made handleable chunks of wall.

Just a quick update on this, the stitch/chain drilling and then using a bolster worked an absolute treat. After drilling 20 holes down each side I used my SDS drill on hammer action with a flat chisel bit and took the wall down layer by layer. the opening was left with surprisingly clean...

Hi, I have put up a conservatory on the back of my house and I am ready to cut through from the kitchen, I will be removing a window and then plan to remove the brick work down to floor level to make an aperture for my new doors to go in. My only hiccup is that the walls are solid and 450mm...

Hi, I have fitted a upvc door to my house and I am unsure about toe and heeling it. I have searched these forums so I now understand the principal for a panelled door, however, my door has a composite lower panel and then a glazed unit in the top. Please can someone advise if I should toe...