Recent content by Steviebabe0

Yep i know, but can u get the part on its own? :lol:

It wont push back on its in two pieces, could glue it or use the old one when I remove it just wondered if the part was readily available to buy in case i have an oops again. :cry:

Having purchased a new diverter valve for my heatslave 9.24 BF, I've accidentally broke the black plastic actuator which fits on the end of the shaft to operate the switches (unless it was sent broke?). Can anyone advise where I can get a couple of spares please before i proceed to replace it...

Forgot to mention I can still get some hot water by putting the heating on to start the boiler, does this indicate the diverter valve assy stck in one position?

Done.

Help needed, I know its old and may need replacing but was working perfect until water board put new pipes down the street (lot higher water pressure now had to renew all tap washers for drips aswell). Since then the hot water doesnt work but central heating is fine. | suspect the flow switch...