Recent content by Tonytog

Thanks breezer

Thanks for the advice guys , I bought some fuses from Maplin today. I would re-wire, but they go into the wall at the corner and I cannot see where they come out? don't forget these were installed by someone who ran them parallel about 3" up behing a 6" skirting..... I may be able to re-run the...

I had to cut through a 6” skirting, no cables visible, however mid way down some bright spark has laid 2 x cables, 1x 4 core and 1 x 8 core look like cat5 type of cables. One went to a sensor and the other went directly into the control panel zone box thingy which is on the wall in the next...

Thanks for your valuable input Jack This is an ongoing problem and I have been advised to go there. for full story see diplomat dishwasher lights on

I have found the dial at bottom LH side. I turned it clockwise and it started a rinse I think . then after a short while it stopped. I could not get it to do anything else , so I turned it again . It went through another small cycle and stopped . The dial reads stop at the 12:00...

Thanks for that . I have returned and foiund the dial bottom LH side. I turned it clockwise and it started a rinse I think . then after a short while it stopped. Itcould not get it to do anything else , so I turned it again . It went through another small cycle and stopped . The dial...

Thank you for your quick response. the machine is in a tenanted property, the tenant has looked and cannot find any numbers, only a plate that has been worn with details that have been worn away on the inside. The right of centre on the front panel ( semi- integrated ) there are 3 lights, IN...

The latch on the door was down and not engaing with the machine, I took the front section of and eventually relocated the latch and got it all working again. however, now all the 3 lights on the front panel are permanently on and the machine will not work. Is this terminal? Advice would be...