Recent content by Walsh

Hi secureiam I did the configuration check and numbers 1 & 2 lit up, which says in instructions that the 2 keypads are configured, as neither of the 2 zone lights were flashing. As the log event shows keypad offline I am confused as to what this means if the keypads show as being...

Thanks secureiam I checked the tamper as suggested and number 5 lit up ( RKP offline? ). Don't know if it as a coincidence but I bought a new R8 control box in Oct last year which came with a remote keypad which I used to replace one that was very grubby. I wired this in myself but got an...

Hi guys Need some advice regarding false alarms on my Veritas R8 system. Gone in to false alarm twice in the last week. In the past I have been able to see where the problem is from the log event, but on the last 2 occasions the log just shows Tamper but not which zone. Can I narrow the...

Hi all I want to fit a Sunvic TLX9201 room thermostat but not sure how to wire it. There are 4 terminals : 1 = common 2 = satisfied 3 = demand and 4 = neutral. I am confused because I only have 3 wires : brown, blue and earth (covered red). Am I right in assuming the earth is a switched live...

Thanks for all advice. Think I need to get a sparky out. It does however state on stat box, 3 wire connection

I have inherited this wiring, so what coluor should it be covered with, black?

Hi Stardanny Thanks for the interest, it's twin and earth

Hi Rob and thanks for a speedy reply. Are you saying my assumption is correct terminal 1 is brown, 3 is blue and 2 is earth

Hi all I have to replace my room thermostat but I can't understand the wiring diagram on the new stat. The old stat was a Sunvic TLX9201 with 3 wires connected. Brown wire to terminal 1 (com) blue wire to 4(N) and green/yellow wire to 3 (demand). Terminal 2(satisfied) had no connection...