Hi All
It is always great to post things here as everyone is willing to help. My UFH got installed 1 year ago and it does not get heated properly.
I notice pipes connected to blue are hot and pipes in red are warm so not sure if engineer has connected pipes properly. I am also not sure on the...
Performed reset as per guide and still same, heat link kicks boiler but after few minutes boiler sign for water goes off but nest app still shows that it is switched ON.
I have called out engineer as it seems issue with nest to me.
Thanks as always for your help and guidance,
Now I noticed the light on boiler also turned off after some time so now I clicked manual on heat link and now I can see lights on heat link and boiler light also turned on for some time now.
It seems issue with heat link to me, any way to rectify ?
Another thing I tested, reseted the heat link and than tried to switch ON hot water, i did hear the click sound within heat link and it triggered the boiler to turn on and I also noticed water sign on boiler switched ON. So it looks good but it did not turned on water sign/light on heat link...
Thanks Stem, currently water is on and heating as well but light on nest is in steady green circle as below:
I think it should show steady green drop sign to show water is turned.
And on mobile nest app it is below:
On nest it is like
On boiler it is like
I tried turning on...
@stem, its been 10 months it was all working perfectly fine so thanks for your initial help.
But from last 1 month I have noticed that heating also turns on with hot water timer so not sure where is the issue.
To clarify heating works as per nest thermostat but it also turns on with hot water...
Firstly thanks for your time and looking into it, yes Red is going directly to Sensor and yes it makes clicking sound when light is turned on.
Looking forward to further assistance
See below, I just opened the light as it has sensor separate so may be possible to take switched live ??
Can someone also confirm if I combine yellow and blue wire will it complete the circuit for other lights once sensor is ON ?
See below pictures
I am sure there must be a way using loop that when sensor triggers to turn it's light ON at that time it can complete the connection cycle for other lights as well.