I have fitted some plasterboard a couple of weeks back using plasterboard adhesive. All seem to be ok but I have come to do some more today and on inspecting the bits nearest the doorframe it is really damp and the consistency of clay.
I can just pull it all off by hand, the stuff further back...
I am attempting to put a fence up along a rather large (150ft) garden. The actual fencing process itself I am ok with having completed fencing at the front of the property successfully.
My question is one of setting out. I need to fence to be at a right angle from the house and to extend in a...
I am about to put a chipboard new floor down in a bathroom and want to level the existing joists as they slope towards the party wall.
It is only a very small span (1m) that needs levelling as the floor that sits underneath the bath has not been removed.
I have looked at sistering the joists...
I am replacing plasterboard round a UPVC window. I have already added expanding foam round the window frame to close up any gaps.
But I also want to close up the cavity round the window, am I safe to use a small amount of expanding foam for this?
I am in the planning stages of building a 3m long retaining wall with 2m wide steps in the centre. I am planning on constructing this with forms and pouring concrete.
I am designing the steps to have concrete slabs on top for a nice finish so want to work out the tread and rise that gets the...
I am about to embark on a loft hatch enlarging project, I am trying to find some appropriately sized timber so I can sister some joists.
My current joists measure 35x80mm, I can't seem to find a direct replacements.
Is this an older joist size that is no longer used?
Not sure if this is the right place for this, building might be more appropriate...
I am attempting to install a fence post in my front garden against a retaining wall. I have dug gown about half a metre and have uncovered a void filled with bricks.
Is this normal? I am assuming it is where...
I am on a mission to stop draughts and increase efficiency whilst redecorating. I am about to put plasterboard back up over a catnic lintel that looks like this...
I have noticed that you can get catnic lintels that have a polystyrene filling, I was thinking of either stuffing it with...
I have just insulated a stud wall with Rockwool Sound Insulation Slab
Now I need smore more for the rest of the walls I have noticed that Rockwool RWA45 is about half the price and looks to be the same product.
I have been trough the datasheets for both products but haven't been able to work...
I am a total beginner to plastering / rendering other than filling the occasional ding in the wall. I am planning on applying a parge coat of Gyproc Soundcoat Plus to an internal party wall which is constructed of aerated block.
The instructions call for a 6mm thick layer so I have purchased...
I am trying to gain as much usable space in a bedroom during a remodel. With a king sized bed in the room it is a bit of a squeeze to get past, so every inch counts :D
I am planning on adding an extra 8ft 3x8 joist so that I can move the stud wall back by 3 inches. The image below demonstrates...
I am trying to replace some missing blocks in my wall after a boiler has been removed
I am struggling to find aerated blocks in this particular size 215x440x115mm
The closest I have been able to find is 100mm, would this be ok to use or am I better off trying to locate the 115mm versions...