Search results

i am installing a new gas hob. the distance from the hob at the back to a tiled wall is 40 mm. is this allowed or is the distance to short.

I want to install my gas hob in the centre of a 1000 mm. hob unit. The unit has two drawers so the centre rail for the drawers is underneath the middle of the gas hob. The work top is 38 mm. and the hob is 35 mm. deep. The distance between the top of the centre rail (chip board) and the...

When I lay T+G chipboard flooring is it better to leave the boards 1 mm. apart or aply Pva to avoid creaking eduardus, stop re posting your question, it is still in flooring where it belongs, you must be patient and wait for a reply. I will delete this post later moderator

When I lay T+G chipboard flooring is it better to leave the boards 1mm apart or to apply PVA glue to the tongue to avoid creaking.

I have just replaced my old floorboards with new 22mm T+G floorboards (600x2400 mm). When I stand on the edge of one floorboard and jolt up and down I can see a slight movement between the boards and it creaks I thought this would not happen with T+G boards. The boards are tight together and...

I am fitting a U-shaped kitchen. The problem is that the wall at the "bottom" of the U is 286 cm and the units to be fitted are 285 cm, so I have 10 mm spare. The units are 570 mm deep and the worktop is 600 mm, so the overhang is 30 mm but the doors are 24 mm thick, only 6 mm left until...

Thank you plugwash, I want to put the flex of the cooker hood into a conduit behind the splash tiles to bring it under the worktop and then plug it into a socket, so everything is hidden. Is it whitin the regulations to place a socket under a worktop?

Do I need a fussed connection unit to connect a cooker hood? Can't I plug it in a socket under the worktop (3A fuse) And the same for the ignition of the gas hob?