Search results

Hi can anyone please advise how to remove the floorhead on a VAX upright U88 MA SE model

Hi and thanks for your prompt reply, ECO mode is switched on and I believe it must be working as for example the shower starts with cold water.

Hi I have noticed my boiler is running (the hot water side), when no hot taps in the house have been switched on. When I get to the boiler, I can hear what I think is a pump running but the flame on the display panel is not "lit". The temperature on the gauge continues to rise before it goes...

This is the only problem I have had with the Easy Control Unit, sometimes I have to re-input the password again, problem happens approx. every two months. Possibly coincides with an update on the App.

Hi mrbrunes, they replaced the Easycontrol unit and carried out a comprehensive check of the boiler. The problem has now been cleared.

Hi, I have a 8000 lifestyle combi boiler with an Easy Control and it developed a fault where the heating would randomly switch on. As the boiler is under a Guarantee, Worchester Bosch came out within a couple of days and cleared the problem. It looks although you boiler would also be under a...

Hi, thanks for your reply, I tried to remove the lever, but it wouldn't budge. Does the top part screw off and leave a small stub to the side of the barrel

My kitchen mixer tap is leaking from the cold outlet only. I can screw back the chrome barrel, but it can't be removed due to the right-angled lever The water is coming out of this chrome barrel. Is there a packing gland behind this barrel and how do you get at it. Can anyone please help.

Hi, I have a PowerMax Complete wireless alarm system (D303983) and replaced the battery on one of the PIR's, a task which I have successfully completed numerous times over the years. On this occasion when I go to set the alarm, I get a message " Disarm not ready to arm, Alarm in memory" The...

Madrab, thanks for your suggestions. I was able to find the plunger pump you had indicated, would it clear sludge or partial blockages in the pipe.

Hi Blup, thanks for your reply, the bath has a direct feed to the soil pipe. The shower and sink may be connected but the shower clears perfectly and doesn't gurgle. This could indicate it is the pipe which runs behind the tiled wall to underneath the floor which is also tiled may have a build up

Hi, I need some help and advice. My bathroom sink is slow to clear and once cleared it gurgles for a couple of minutes. It is not the You bend has I have replaced it. In the bathroom I have a shower and bath and both are working perfectly. On the bathroom sink there are 2 right angled bends in...

Hi Khan82, apologies for the delay in responding, I was off on a short break. Very interesting reading on the thread you quoted. I checked my boiler and it takes approx. 90 secs to return to CH if the DHW is switched on . This annoys me as my rads takes a long time to fully heat up. I have 14...

Hi Khan82 No issues with my boiler, only minor issue I had was with the Bosch Easy Control. When i changed the program times after the winter period, it stored them only for a week and after 7 days it reverted to the previous schedule. The Bosch helpdesk were great and talked me through a...

My sunroom which has been built for 15 years, the rendered wall below the windows has started to bubble in some areas of the rendered wall. This has only happened in the last 6 years approx. I have scrapped the bubbles off, used an Crown Alkali Resisting Primer , repainted with Crown Exterior...

Hi thanks to all who responded. I want to remove all the original protector, as I'm worried that the new coating either Stain or Pil will peel. I had though of reversing the boards bit I would need to renew 5 of them due to cuts to fits posts.

Hi thanks for your reply and the link. I have a small wire brush which fits in to the grooves perfectly but it doesn't lift the previous protector. I'm using a small metal file which takes some of it off but I'm still left with a residue. Has anyone tried any decking stripper and which was...

Hi, I would appreciate some advice on how to remove Ronseal Protector from my decking. I have used it each for around 4 years. I have power washed the decking but now I'm left on how to get the Protector out of the grooves in the decking. I'm using 60 grit sandpaper but unfortunately it isn't...

Thanks for your reply, it is a Combi boiler and I checked at 18.10 and the boiler switched on. I could hear water going in the boiler and the pump running but the boiler didn't fire up.

Hi, I have a Worchester Bosch 8000 Life, 35KW and I have noticed every evening at 18.10, the boiler automatically fires to heat the hot water. No hot water taps in the house have been turned on. Is there a timer in the boiler which programs this feature to happen