Search results

Hi I think there must be a bearing going due to the increasingly loud noise made during spin cycles. I haven't taken a look yet but does anyone know the best way to dismantle and check whether front or rear bearing (I assume there will be play) need replacing. Thanks

Due to a leak caused by the top of the soil pipe crumbling and breaking away I want to repair using a straight connector. I have 2 issues: 1. The pipe will need to be cut in order for the final level to match existing and space is tight. I have a 4 1/2" angle grinder which may just...

My CH comes on with HW and vice versa, any ideas? I have a Honeywell 2 channel timer, Honeywell programmable room stat and Honeywell wiring centre. I don't mind the HW working with the CH as the towel rail runs from the primary so need it to be on when the CH is on but not the other way...

Hi Does anyone know if you can use non Glowworm timers and programmable stats with this model. I have a Honeywell CM907 programmable thermostat already which I'd prefer to use and so only need a timer. Anyone know if the options board is only needed for Glowworm accessories or as the basis...

When my dishwasher runs through it's various rinse cycles (not on initial fill though), it causes pipes to bang when it draws water. It's connected to a standard appliance valve on the cold water supply. Any thoughts? Many thanks

I've just moved in to a new house which has no room stat for the central heating. The programmer controls both hot water and central heating which you can select either hot water operation or central heating (which I assume also heats water at same time). I've just bought the above room stat...