Search results

  1. F

    Adding a shower but need waste to run about 5m or so

    Hi I want to add a shower to an existing bathroom. The total waste run will be around 5m, which is much greater than the DIYnot suggestion of a limit of 2.3m on 38mm pipe. What are the likely problems? Are there ways around these? Also, can I link to the bath waste (would still give me...
  2. F

    Turning a solvent-welded soil stack tee

    Hi I have a two storey house. The soil stack is internal and constructed with solvent welded joints. It runs from the ground up into the cloakroom where there is a loo and basin, then on up to the upper floor where it passes through the bathroom (loo, basin, bath) and then through the loft...
  3. F

    Hot transformer in bathroom light/shaver unit

    My step dad has recently replaced a bathroom wall light fitting. The new unit is made by "Ring" and has a shaver socket. There is a transformer inside, I am assuming this is for safety isolation of the shaver socket. The surface of the unit is apparently hot near the transformer, hot enough...
  4. F

    Rating of "low energy" bulbs versus the lamp shade

    I bought a lamp shade for use on a ceiling pendant. The label on the wrapping for the lamp shade stated it is rated at 60W for a conventional incandescent light bulb, or 11W for a low energy "60W equivalent". The room is a little on the large side for a single pendant but up until now I have...
  5. F

    Earthed dishwasher touching earthed sink - good or bad?

    I am just about to finish refitting my kitchen, the last item going in is a built-in dishwasher which is under a worktop. The drainer end of the stainless steel sink is partly above the dishwasher. The dishwasher has two screwholes in its metal chassis above the door, which you are supposed...
Back
Top