Search results

Hi all, You have been incredibly helpful in the past and therefore I am hoping you can help me again! I have a radiator problem. Since moving in, the radiator upstaris in the spare bedroom has never been able to get hot. This was installed by the previous owner. All other radiators in the...

All, I always come back to this forum for help and have found you guys extremely useful in the past. About 6 months ago I had a water softener installed outside my kitchen, which I have since boxed and insulated. In the last week I have noticed that we do not have soft water in the...

Guys, Installed new conservatory over the last few months. I need help on two things please. First one, the windows have spaces for vents, I have the plastic vents, but have no real idea of how to fit them please. Can you guide me on what vent goes on what side of the window...

Hi everyone, Firstly can I say that so far my experience of this forum has been brilliant, with loads of really helpful people giving great advice. For that I am thankful! Ok, my next project is building my conservatory. I have built the base, walls, etc... and now I realise that I need...

Hi, Just finishing off the base of a conservatory (my first home built !) The unit is 4m by 4m. I have membrane with is 4.2m by 25m in length. Question is, when I lay the membrane down, I understand I need to bring it up the sides. Considering it will only come up the sides my 10cms...

Guys, Need some help diagnosing this alarm. I have the engineers code. In the past I have decorated the living room, which contains a PIR. I neglected to put the system into install(engineer) mode and unscrewed the PIR to run some wall paper. As you can guess, alarm went off, etc...

Guys, Firstly, you are so very helpful, so a big thank you. I am trying to figure out the final bits of my UFH puzzle and would appreciate some final advice. This is my UFH manifold. The bottom copper pipe comes from the boiler, through the main pump, into a motorised valve, then...

Guys, I am trying to get an understanding of the components in my UFH system. Could you correct me on my understanding of the items below? Thanks. Doobs. (Thermostatic Mixing Valve?) (UFH Pump) (Manifolds - 22mm or 28mm?!?) (Motorised Valve) (No...

Guys, I am trying to get to the bottom of why my underfloor heating isnt quite working correctly. Firstly, I have two manifolds. The Bottom manifold is where the hot water comes into the system. The water then flows to the output valves. These are open or closed. Currently all...

Hi guys, Firstly can I say how helpful everyone has been on the forums over the last fews days. You have helped me replace a thermostat, replace a syncho motor and now I am asking for a little bit more assistance please! I have underfloor heating that works of off 2 manifolds. (Picture...

Hi guys, Need some advice. The situation is as follows. I have radiators upstairs in the house, controlled by their own control panel (allowing me to set the times that they come on). This works perfectly. If I override the setting, the boiler comes on and they fire up. Downstairs I...

Guys, So I am replacing an old thermostat with a new one. The old one is a T6360B type, with 4 wires connected, including the earth. Earth - 1 is Red, 2 is Blue, 3 is Yellow The new one has 3 spaces (A, B and C). Which wires from the old go to the new...