Search results

Hi - can anyone help with the below? I have a typical upvc front door with a locking strip down the side. To lock the door, the handle is lifted to engage the strip in the door frame and this allows the key to be turned to lock the door. Lifting the handle no longer engages the locking...

Have checked the inlet fuses and they are fine,. Bunnyman you have noted that the red/green buttons can be sensitive, what can a man do in checks or resets ? Appreciate yours and anyone esles views. Thanks !

Will try the fuses on the inlet and get back to you Bunnyman. Thanks to everyone for their replies.

Put box back together, pressed rubber nipple but to be honest didn't feel a switch or anything like that , seemed like a void.This was done with the electric off if that makes any difference. Pilot light has come back on but constant or timed command from timer doesn't make the boiler kick in...

Thanks Bunnyman good to have you back. Will press the button and see. Thanks for everyones replies.

Sorry mate you must think I'm a right one. Can see a rubber nipple at the back rh side of the outside of the pcb metal case. Would this be it? Do I have to have power to the boiler to reset ? As I have the front of the pcb box open is there anything i should check. there are 2 fuses in a little...

Got inside the metal pcb box , cannot see any switch on the rh side. I see the pcb on the lh side, the micro switches on the centre the only thing I can see on the rh side is something like a bell with RANDO on its side and this has no switch or moveable part. Hope this explains what I'm looking...

Thanks for the advice Agile ( Tony) will give it a go and get back to you. Thanks House 123

Thanks for replying Agile it is appreciated. I haven't check the overheat stat is tripped. How can you tell if its tripped, and if so how would you reset it ?

Have just done the relighting procedure but no change . Any more suggestions Bunnyman ? Thanks .

Thanks Bunnyman. have checked the pump and its not stuck, no problems moving. Have also checked electricity to boiler and its juiced up so fault could be more serious. Thanks for everybodys replys .

The added window looks into the walkway between the two houses so it's only facing the opposite brick gable wall. Thanks for everyones replies.

Thanks for your reply Jeds. The house isn't listed or in a conservation area. The planning officer was reacting to a neighbours complaint and stated that it broke building regs due to the fact you couldn't enlarge the glazing area so I'm not sure where I stand ?

Checked the pressure and its 1 bar. Timer is ticking so I take it is working.No reaction to timer going on constant, or by adjusting the room stat. Thanks for any replies !

was told by planning officer that additional window for new downstairs toilet should not of been added as the law states you can't enlarge the glazing area on the gable side of the house.Have now the option to brick up another gable side window under stairs and keep new window or remove the new...

Went on holiday and turned water off in the house. Since coming back off the holiday , water is back on but combi won't kick in when activated by timer or by hot water tap being turned on. The pilot is on .