Search results

Hi Guys, I would never dream of being abusive to anyone for being honest and truthful, I am not Qualified to do this job and although I know I could do it, I would never put anyone (public or employee )at unnecessary risk by doing it when it must be certified. I have informed my boss and show...

WOW.. I thought it would be a simple Job I could do myself, but it appears not, I will let the boss sort out a Spark and get the job done by a properly Qualified, Competent, and insured SPARK. I thought a simple ring from the CU using 2.5 T&E would have sufficed. Thanks for your advice guys...

I wish to install 10 double 13amp sockets mounted on PVC trunking, Would you suggest Ring or Radial circuit, they are all mounted within two 3 meter lengths of trunking joined together (6 meters) using 2.5 T&E cable. The sockets will run up to 20 televisions on display in a shop. Any advice...

I did check the brushes, it was the first thing I check I think, but I forgot to reconnect one of the supply wires to the brushes, many thanks for all your help once again. Regards Jim

Continuity on the Motor to PCB cable is good, as is the continuity on all other cables within the wiring harness,(took ages to check them all) No it wont fill with water, When I select a program the wash light comes on (along with on/off) then nothing happens at allfor about 1 or 2 minutes then...

Hi guys, I have another WF541, with a wee problem I hope someone can help with, It powers up, I select SPIN program, after a few minutes of NOTHING, the DOOR LOCKED light flashs. Changed the door interlock, checked the NTC, checked Heater Element, Checked Pressure Switch, Checked Motor Brushes...

I use Hotpoint and have done for 28 years, no major problems, I find most are fairly simple to repair unless its the drum bearings, HOTPOINT is not related to Zanussi, Hotpoint, Creda, Indesit, Ariston are all the one company, Zanussi, Electrolux, AEG, Tricity Bendix are all the one company...

I had one of these machines and ALL lights were flashing and I was unable to select any program, I took the main PCB module out and had a look at it. I noticed one of the Capacitors on the board was bulging, hence it was blown, I de-soldered it from the board, I purchased a 680uF 10V 105C...