Search results

I've installed a 3.4 bar pump - 22mm piping into loft - tees off to tow bathrooms/two showers - 22mm continues to new bathroom right through to mixer - 15mm to old bathroom to existing mixer - when new bathroom shower in use, old bathroom shower only cold - will that be the case until I change...

Just installed an Ideal Create Edge BTW pan - have connected to the waste with a new female connector onto the male waste protrusion on the pan - the protrusion is not as long as I've seen before, but it seemed OK for the connector - but when I turned the water on and flushed the first time, the...

Moderate DIY use - will go for 18v - and a 13mm (1/2 inch) chuck - must have two batteries ... Anyone got any current product recommendations???

If I search for an answer to this question, I can't get my brain round the answers I get!!! I'm screwing a male shower hose connector into a female oulet (buried into the wall) ... In which direction should I wrap the PTFE tape onto the male hose connector if I'm looking at it from the end...

I am fitting a shower hose for which I embedded the threaded fixture into the wall before the tiles were fitted, thinking that I had left if proud enough to be almost flush when the tiles were fitted - what I hadn't banked on was the need to pack the tiles out to compensate for an out-of-line...

I am fitting a new Carronite Swallow 1800 bath ... (http://www.carronbathrooms.com/Carron%20Bathrooms%20-%201800x700.html) ...with a Hansgrohe Exafill S filler/overflow ... (http://www.hansgrohe.co.uk/uk_en/110381_32313533305F32355F3632313539.htm) ... so have a overflow and waste...