Search results

The burner is doing the prestage ok then locks out. Loads of oil. I loosened off the bleedscrew and there is a lot of air coming out. There doesn't seem to be enough oil in the tiger loop and then air is getting sucked down.

The system is about six years old and has been working fine and serviced regularly. Today the better half switched on the heating and a while later we realised there was no heat. I've never actually had to look at it myself before as it has never stopped. The tank sits a few metres...

Thanks EFL You've summed it up it was just in case they got another one and I would break it too

Sorry Chri5 It's working with a standard type rose with 100w bulb the chandelier isn't working. And your description if the of wiring is correct despite my inability to describe it in english

Seven small bulbs, I thought the 40w bulb blowing could suggest I've done something wrong? That has helped the fault develop.

I'm the first to admit I'm no electrician but got forced into this one. The in laws asked me to put up to chandelier type lights on at the bottom of stairs one on the landing both have been working for a year until now. The upstairs light isn't working. The light was switched on and it blew...

Thanks securespark, I am not going to use the alarm circuit. Just going to leave it as is. Ban-all-sheds good to know you can read my mind, oh and thanks for not reading my previous posts and jumping to conclusions.

Thanks thats all I wanted to know from the start

I asked will a 300w bulb work on a 3amp circuit, can anyone answer that

The idea was it would heat the roofspace I know alot of people who do it who had no problems, I don't know why people keep refering to the tank I had no problem with it. I asked would a 300w light run ok on a 3amp circuit. Yeah trace heating or a blow heater would work but that requires alot...

Im not putting it under the tank, the tank did freeze the pipes did there is insulation on the tank. I have mounted a 300w light with nothing within 2 square metres. Just forget I said anything

Im not looking something complicated like trace heating or to have to go through suspended ceiling to get at the light ciruit. I just want to know can I wire a 3amp switch to a 300w bulb sorry just want to keep it simple

Its a bulb not an exposed element and the bulb was mounted so as to be nowhere near anything flamable. The pipes are already insulated but they still froze

With the cold weather and a close call with frozen pipes I had a 300w infra red bulb on an extension cable in the roofspace. I was hoping to wire said bulb permanently in the roof space but the only power up there is the alarm control box. In the downstairs fuse box the alarm fuse is 3amp and...

Thanks for the advice I understand the thinking frustrating all the same lol. My parents have a mira cant remember what model but its cold water feed only from the attic which is always alot warmer with similar power, any suggestions for a good 10.5kw shower

When I adjust the temperature too the highest it is luke warm bearable but pressure is low, the cold weather has made it worse obviously because the tank is alot colder. The house is about a year old now bought as first occupants and the builder had fitted the shower. Any help would be greatly...

Two valves where connected wrongly swapped them all seems to be working fine now thanks again

I have a multimeter just not so hot on using it lol. There is a "junction box" above the valves. All the wires coming out of it into the valves have all the same colours into one connection, except for 3 brown wires one from each valve. Do I put brown to multimeter and ground to multimeter

ive a system consisting of a channelplus xl nlh37 control panel, two hrt2 thermostats one upstairs one downstairs, an hct2 on the immersion tank and three f222m/i valves. The problem I am having is the thermostat for the down stairs heating is controlling the water and the thermostat for...