Search results

  1. B

    tap problem

    hi guys, i have a mains pressure system in my home all of the taps are mixer taps(except for the garden) in my downstairs bathroom the hot water does not come out of the tap at all, all other taps inc shower function normally, pressure is at 1.5 bar. any ideas? its a bristran...
  2. B

    servis m6702+ scrap? please help.

    hi guys, i have a servis m6702, that has lasted me well, recently i replaced the pump, no probs there. I have a new problem, it tripped out the circuit breaker, so i investigated further...... opened the top and saw the power transformer had some soot on it, managed to get a working one so...
  3. B

    baxi solo pfl50 nearly there.

    Hi i have a baxi solo pfl50 boiler(boo!) It had the overheat problem (boooooo) I purchased a new PCB(horray) removed my old one(hmmmm) plugged it in(ok) forgot which electricity supply wires go where on the PCB(doh) please can anyone help? I am faced with 7 possible points to connect...
  4. B

    baxi solo3 pfl 50 pcb overheat, whats the solution

    Hi all why does the overheat pcb fault occur, what can be done to remedy it? I have to purchase another board bu ti really would like this time to be the last.
  5. B

    baxi boiler is allowing rain inside expert opinion required

    Hi all i have a baxi solo pfl 50. It was installed by a CORGI engineer about 24 months ago. I have 2 problems 1 is more pressing than the other. It was really rainy here in herts last night and when the boiler switched on to heat the water last night there was an electrical shorting sound and...
  6. B

    finishing off the job

    Hi all i have a small problem. My installer rewired my house(no probs) added a fusebox to the garage (no probs) did not install the light or plugs that i needed ( probs) I cannot get him back to finish it off so i need your help. I hear talk of rings? should i just run the cable out...
Back
Top