Search results

Hi All, Thanks for your advice did not mean to start WW3 on the board! The method I used was to turn the siren tamper to off remove the siren from the wall (up a ladder) switch this to off and remove batteries incase of leakage as it may be stored for a bit. I then removed the panel...

Hi All, I have a yale HSA6400 which I installed after xmas last year, all installed ok and has worked fine since. I am in the process of moving soon and will need to disable/decomission the alarm to take with us to the new property. i have re read the manual and checked the dvd also...

Hi All, I have today discovered the washing machine has been leaking for an unknown amount of time at the back, it was tucked under the counter and due to the floor level tilting slightly back the water has been dripping out onto and then under the floorboards, I have for some time...

Hi All, Not sure if I am putting this in the right forum or not so apologies if I have it wrong, however I have an issue which I am hopeful someone on here might be able to help me with. I was supplied a lh pull out carousel by howdens for my new kitchen however they should have supplied a...

By pump over I mean when the heating or hot water is switched on and the pump runs water comes out of the vent when it is hot over the F&E tank which then heats up the water in the tank. The pump has been set at two since I moved in and never adjusted it until today. The water in the F&E...

Have checked all rads bar one in the spare room as cannot get the bleed valve open and all radiators are ok. Not sure if the below is going to help but.. I am going to run the ch system for a few hours this afternoon and I have pushed the pump up to setting 3 hopefully getting more air...

The rads all get hot at the top so I figured the rads are ok. Will go round and bleed them today and get back to you to make sure. Only problem I have is the previous owners painted all the rads with matt paint and its difficult to open them all.

Many thanks for the replies, I have tonight done a little test to see if the coil has indeed got a problem inside the cylinder. I ran all my hot taps for 20 minutes, while the system is cold and I switched off the power to the boiler to be sure, this was to draw water through the system and...

Yeah F&E tank has a lid & insulation padding around it all. It does pump over quite a bit and the water is quite hot steam when I open the lid to check it(if the heating or hot water is called).

Your right, I believe the F&E level will be lower than the cws but probably not by much. The walls are plasterboard dot and dabbed on breezeblock think they have used 10mm pipes to rads and put this inbetween the plasterboard and the breezeblock. We have only just started to use the...

Hi, Thanks for the replys, my tanks are in the loft both at the same level sitting ontop of a wooden support spanning two beams in the loft. The water in the cws (big tank) is cold. Neither tank is overflowing. The only part of the house which is has under floor pipe work is the...

Hi all, Not a whizz with central heating as I am an IT network administrator by day so in need of a bit of help. My ch system is an open vented system with indirect hw cylinder. In may this year we had a rad leak in the bedroom and replaced by british gas. Came back of holiday to...