Search results

Hi I am hoping to put a moulding around my stairs. How do I work out the angles highlighted in the picture? Thanks

Hi I have a Grant Vortex Oil boiler which is only 2 years old. This morning the boiler didn't heat the water or radiators and still have 3/4 full tank of oil. I looked at the boiler and the red reset button was not lit but i remembered the installer saying about the Overheat Reset button so i...

Hi What is the highlighted part on the door in the picture called and where can I order it please? Thanks

Hi All I have a 25 ltr low energy dehumidifier which I run 5 hrs from midnight to 5 in the morning. It is in a central location of a 5 bed bungalow and still get a bit of condensation on some of the windows. In people experience whats the best way to run a dehumidifier? The max wattage is...

Hi Would anyone know what the name of this green board is in the picture? Want do to this on my stairs. Thanks

Hi I want to upgrade my old fluorescent tube under cabinet lighting to new led ones wired to the mains. These are switched on when the cooker hood is switches on. Anyone on here done this and what led lighting did you use? Thanks

Hi I am converting a garage and my BC plans say that I need 150mm Kingspan floor insulation with dpc, membrane and 25mm edging then 75mm sand cement for floor. I need 12 sheets (2400mm x 1200mm) and due to cost would it be OK to put down 75mm polystyrene boards then top with 75mm Kingspan...

Hi I am planning on building a timber structure to have an enclosed bar and BBQ area. It will be about 8 x 4 meters so will need a base around 9 x 5 meters. I am building it in back garden which has been a a garden for 30+ years. Any advice how to construct the base? Thanks

Hi I have outside lights which I have a junction box connecting. I want to install 5 more Bulkhead lights on a fence up the drive with a sensor wired before the 5 lights so all will come on once movement is on the drive. What cable would you advise to use? About 50 to 60 meters in length...

Hi Has anyone order a set of patio doors with glass side panels from an online company at all? Just wondering any reviews of some - based in NI by the way. Thanks

Hi I think my cherry blossom is grafted as seen in the picture. Is it just a mater of cutting the branch where the red line is drawn? Thanks

Hi I planted a laurel hedge last February 2 to 3ft high, the wind last night has broken one of the stems on one of the hedges can this be taped up and strenghtened so it can grow? Just the height is now 4 ft approx and want to keep as best as possible. thanks

Hi I have the same tile as in the picture and every year the starlings nest under the tiles just at the guttering. Would a small insert of expanding foam stop this or would this not be recommended. thanks

Hi Just wondering can I get french doors with side windows 2200mm in height? I know the standard is 2100mm. Thanks

Hi What's the best product for cleaning pebble dash that doesn't harm pvc window frames? Also, can this product be used on the roof tiles as well? Thanks

Hi Just wondering I have a car pit in my garage which I am going to convert to a room, would anyone know if I get the measurements how much roughly it would be if I put glass over the top of it like a wine cellar?? Thanks

Hi I have a old flat panel radiator in a bedroom which is connected to 8mm micro bore with a single end connection that has a rod running inside the radiator to control the flow/return. I want to incorporate the radiator onto the 15mm flow return (bungalow), is it just a matter of...

Hi I am going to dot and dab a garage with insulated plasterboard, should I do this before or after I have my floors insulated and raised? Thanks

Hi I have seamless guttering on my house but at the back door there is a 90 degree joint that has split and is leaking when walking into house. Would there be any quick way to fix this? I have to replace the whole roofline at some point and not PVC, was just looking something to do a simple...

Hi I have installed a multi fuel stove few months ago but did not want to have spots wired as was afraid of the heat causing trouble. Has anyone done anything different to light up the stove insert area? I was thinking of battery push LEDs behind stove when not lit!! Thanks