Search results

Hi, update on the Thermostat problem. After further playing with the system, I established that the transmitter was transmitting, and the receiver was actually receiving the information, but not firing up the boiler. So I " deconstructed " the receiver unit, couldn't see any evidence of any...

I suspected this might be the case, I'll most likely change to another make, ( think the B/Gas units wil be double any one else's price ) thanks for all the help, appriecate your trouble Jeff

Hi, already done this - thanks for info - two or three times, so either the tx or rx is at fault, how do I decide which is my problem !! Jeff

Yes, that's correct. I've worked through the checks, changed batterys, set the controller in manual mode - flame indicator comes on, goes off depending on set temperature, but can't get the red light on the receiver to either flash when carrying out the rf check, or go off in use. Jeff

Hi, model isRF316/22560, make is just shown as british gas RC plus Jeff

Hi, My RC Plus thermostat appears to have packed up. it's not the boiler, shorted out the link for the thermostat, all ok. Now, it appears the RF signal isn't either being transmitted or it's not being received, accrding to the instruction leafletl Any Idea how I can work out which unit is...

Hi, thanks for the drawings. Only difference will be mine will have to go through the "roof" of the pit which is about 2ft below ground level, clamped to the lower section of the pit wall, with the rod point just above ground level. I've found a slow bend specifically for the bottom of the pipe...

Yes Understand that. Just to ask again, is it in order to have the waste pipe outside, with the rodding point at the right angle where the pipe comes through the wall and drops down to the chamber?Jeff

Thanks for the information, great can do!!!

I'm looking at the feasability of fitting an extra toilet in a large cupboard in our bungalow. It is against an outside wall, directly over the main sewer which is about 2metres down, with an inspection pit very close by. Does it need a vent stack pipe, and can this be outside? Also, does the...

Thanks for the suggestions and help, it has certainly given me lots of options to think about and materials to consider using that I didn't even know existed !! Jeff

Thanks for the reply, nice job by the look of it. One point , does the UPVC cladding need a under layer of waterproof ply, or is it ok on it's own ? Jeff

Hi, new to the forum, thought someone might know the answer to this. I want to add a small extension ( 2m x 4m ) to the rear of the house, which is build up with block retaining walls. Due to this I want to keep the weight down, and am considering using a timber frame, UPVC clad on the outside...