Search results

cheers. what do i with regards to the boiler, ie switching off, leaving it, resetting it? and re filling it. dont want to balls up the sensor again

hi all, i need to install a new radiator to a room without an existing one so i need to drain the system. i have a vailant ecotec pro boiler fitted. i did drain the system a couple of years back to move a radiator but i then had to have the water sensor replaced, not sure if i did...

i would do it the way they've said, it will look fine

no not at all

what is the max thickness between the frame and beads (strips) you will need at least 14mm

depends if there is enough room for one

we sell restoration glass for what you are looking for but it is quite expensive

take the unit out first then try to open it.

most front doors come with a complete panel and you cant change the glass you have to change the whole panel. you can get doors with clear glass for no extra cost ,depending on what you want, may sound silly but try looking at back doors you may find what you want

yeah he pumped it up but its leaking. said it would probably last the summer but not when the heating strats being used constantly. going to get the external one fitted when i can

someone came today and fitted a new sensor. its working for now but needs a new vessel. he said my best option was for an external one? got to ring him later and speak to him about it

there is power going to the board and pump but the boiler is dead, no lights or fault codes. this happened after a drop in pressure due to a leak on the pressure sensor . pressure is back up but boiler is dead. all fuses ok.

there is power to the board, not sure about the pump. how can i check?

hi, i have a vaillant ecotec pro and it looks like i need a new pcb. just a couple of things i need to know. how can i tell which model it is so i order the correct pcb, and are they difficult to change? and how much should i look to be paying for one? had no heat or hot water for nearly 3...

yes remove the glass and go with flag i would. easier to do on your own

lady lola:- it was tongue in cheek. when manufacturing dgu's the whole process is done by machine hardly any man involvement, thats the very big firms anyway. the small local firms all do it pretty much the same way as each other where 1 or 2 men cut the glass by hand cut the spacer bar by...

hi, what you are doing is all very new to me but could be worth a go. the problem i see is with the dessicant. i always throw away dessicant that has been exposed to the atomsphere for more than 8 hours because i deem it useless as it causes dgu's to steam up when sealed (especially in winter)...

the door is probably fine. your lock is knackered. firstly does the key turn at all

yes you can do this to leaded units thats what i meant by decrotive dgu's and these are the most likely that need repairing. you just have to be carefull not to damage the lead when doing so. the most common sealeant is, what they call in the trade, hotmelt. this comes in a number of...

if you want to repair a broken down or "misted" dgu the best way is this. 1/ carefully split apart the two panes of glass with a stanley knife. slicing where the glass meets the spacer bar. (be very carefull and take your time. you will need to slice each edge a number of times) 2/...