Search results

tested out all bits all tested ok. checked components on control module they all seemed to check out ok. So easy way.. throw on scrap heap and bought another one thanks for all the help offered Spent last 20 years repairing industrial ones. they are a lot easier

latest !!! drain pump runs on bench....circ pump runs on bench 1 without cap it buzzes needs a push start and away it goes.. 2 with cap in circuit and 240 across the 2 terminals in plastic plug in wiring harness no run changed cap same result .... heater heats up on bench put back...

both pumps removed and checked and run on bench... heater removed and checked on bench. pressure switch and solenoid checked all in order. any data or info on checking out control module.

thanks rocks will get on the case imediatly

small amount of water on floor under l/h side front no more than an egg cup full when working... loads of white hard powder on door seal now cleaned off.. no sign of any water spraying out anyway. looking under at pumps and stuff everything looks pristine all wireing looks clean and tidy...

thanks for that rocks. done that and removed water..... cleaned door seal swiched machine on. no lights... machine went through procedure water filled up then waited and waited. ... opened door and found water cold. removed water by hand checked out heater this seemed ok reading of 25 ohms...

tryed that everthing secure but lights still on and no action doesnt seem to reset when i hold reset in for 10 secs

the fibres in lime plaster is horse hair and wouldnt be a health hazard but as denso 13 states you must be aware of updates to plaster and sure it is of that date.

thanks rocks ERM whats a Ntc

help! anyone out there that knows what the light fault codes mean I have the two reds one above the other on the left flashing in unison slowly think they are low salt and low rinse aid. and the 4th light from lefthand side think its eco45 flashing fast thanks for...

sorry to cause so much bother with my op thanks to the first two engineers have now located and fitted the valve and sensor. for the imformation of the others. I use this valve to control the hot water temp in a calorifier heated by engine cooling water on a narrowboat.

anyone know who makes a 3 way valve with a 2 meter capillary and bulb sensor.