Search results

Are you saying swish will discolour after a few years ?? As you have said ive used eurocell for my whole working life so I'm a tad concerned about using a different make etc but £200 is a lot of money !!

Hi At the moment I'm working away and need fascias soffits etc Just wanted to compare quality between swish and eurocell ?? I ask because there is a £200 difference in cost with eurocell being the most expensive. I usually fit eurocell and have never heard of swish before today ! Any...

Anyone ?

hi As above I have a alpha 35c combi boiler and I have no hot water ! The heating is fine ! I have a green led on D so I have power When the wife turns on the hot water C led lights up Amber then goes out Am I thinking a blocked heat exchanger ?? This has happened before but the water...

Anyone ??

Hi all I own the above a hotpoint ffa74 and the high temp light is on for the freezer compartment ! Touching the outside of the freezer area is hot to the touch ! Anyone have an idea what my problem could be ! Many thanks

I had the 30 mm bearings and refitted the correct size the picture is not mY spider my spider is worn a lot more than this so I may replace it as a mater of coarse to rule it out any other ideas ? As I said there is a slight bit of play in the drum another thing I noticed is when fitting the...

my spider was a little worse than this but the bearings felt as if they sat on it tight but maybe not tight enough ! Would you replace this spider (one in pic) or reuse it ? Just trying to gauge if changing the spider will sort the issue I have , as said in previous post there is slight play...

All reassembled but still has this annoying load noise happening ? I have pushed the metal drum up the turned it an inch the pushed up again and so on around the whole circumfrance and it does feel if the there is a bit of play ie 2/3 mm is this normal ?? Or does this indicate the spider ?

Just restriped it and can't see any visible cracks on the spider I have noticed that ther is some wear on the stub ( where the bearings sit ) I have taken the bearings back out the drum and put them on the stub where they would be positioned in the drum they are sat on there tight ie no movement...

What do you mean support (spider?)

I used a new heater and put the old bracket ( heat shield ) to it

Both weights are all tight as for the Hester bracket please explain what this is ? As it's a push in item with one bolt to secure it I do refit the old heat deflector to the new element though .

I have removed the belt from the motor and spam it by hand and no noise from the bearings I did hear a slight scrape from the drum though I have also fitted a new heater element could this be the problem ?

All nuts are tight even the pulley bolt thanks though

Hi In a bit of a fix !! Just replaced the drum bearings on said washing machine all went well and is back together ! I put it on a rinse spin cycle and all was good no noises etc but then went for a wash etc and when it was spinning I heard a clicking / ticking so while it was still going I...

Hi I have an issue with the top oven temp switch 1 it doesn't work and 2 when I switched it on by accident I had a slight smell of burning wire Can anyone confirm my issue being the switch stupid question I know just looking for a second opinion Many thanks

As above I have an issue where the paint is peeling off of new coving !! I think it's due to the decorator painted over dust by the looks of it is there Anything I can do to stop it as I don't want to go to the extremes of replacing 20 metres of it many thanks

So what's the difference between a single or a double ender then (no pun intended ) but still so lol!! And or Stanley fat max extreme or stabila 96-2 ??

I need help making a decision !! As title I want to purchase a set of levels but I'm stuck between Stanley fat max extreme or stabila 96-2 range I want something decent but don't want to pay too much (the normal thing ) Any help would great Cheers