Search results

We are looking to replace our internal doors, white panel variety with modern "oak" doors similar to these: Howdens Dordogne Oak Pre Finished Door | Howdens There are about 25 in all, but some of them are widths and heights which are non standard. My question is can a good chippie remake these...

Does anybody know what this little gadget is for, it came with the frame but doesn't appear in the instructions? TIA, Colin

I am replacing a Honeywell ST9400c Controller with a Hive. The wiring diagram for the Hive shows terminals 1&2 as HW & CH reserved for "Off" . On my existing Honeywell no wires are attached to these terminals, see attached image but there are 2 spare wires taped up but not connected. If I wire...

Presently we have an oil fired boiler serving the CH/HW it's a pressurised system with a water storage tank. Controlled by a Honeywell Thermostat (located in the hall) set at 22c and a Honeywell ST9400c programmable controller (located in the kitchen). In everyday use the HW runs on a programme...

My existing tap (brass) leaks and has been there for about 20 years and resisted all efforts to disassemble it to replace washer etc. It has a 22mm (?) male thread inlet and is connected to the plastic supply pipe by a screw fitting female adaptor. My new tap has the same inlet connection but...

My query is pretty basic and concerns just what is involved on the "electrics" side of the installation. Firstly we have a meter with separate day and night readings (Economy 7?)and the conservatory has four dual 13 amp wall sockets and our consumer unit (Crabtree Starbreaker) was installed 2...

I know there are several old threads on this topic but I would appreciate your advice. Curently I have a 4360 f/stat wired T1 live/T3 neutral. I have a 641B pipe stat I want to connect up and I need to know exactly where I need to connect the feed from the pipestat to the f/stat. Looking at...