Search results

I disagree, if the concrete subfloor is correctly insulated then the underfloor heating will be more effective without the compound. aslong as you use enough adhesive to cover the elemant what wld be the problem?

i need my kitchen stripped back to the plasterboard as am re decorating it. how do i know the existing paint is rubbed down enough and the old tile grout? and whats best to use to remove paint?

Your underfloor heating should have its own 2.5 radial backed up by a 20 A rcbo. your fusebox is dated and your installation does not comply with the 17th edition regs. Get your Periodic inspection done and pay for the remedials!!!!!!!! standard

Well as i havn't purchased the heat matt yet, they do not say anything

is it really necesarry to lay self levelling compound on top of your heat matt before laying your tiles on your floor? can i just put tile adhesive straight down?

when laying electric underfloor heating, is it necessary to put self levelling compound over the heat matt before you lay tile adhesive? some companys recommend you do and others dont? please help?

is this floor setup for underfloor heating correct? flexi tile adhesive insulation boards heat matt self levelling compound flexi tile adhesive tiles and grout let the force be with you!

should i get in skimmed and do i have too?

i have taped and joint my ceiling and am happy to paint it, whats the best paint to use on a kitchen ceiling?

r u a painter?

i Have just re boarded my ceiling and am happy with the taping and joining. i have rubbed it down and its ready for painting. its in my kitchen, is it ok to just paint on matt emmulsion ??????

once i have re-boarded my ceiling and tape and joind it, can i just rub down and paint straight away and what paint do i need to use.

and p.i.r's

Thats great! the property is mine so its not an issue. Are u aware of a new system i could install comapatable with all existing wiring and just replacing the bell, touchpad and PSU?

at one point it also displayed lid tamper

i am aware of where i disconnected the sounder from and yes i am a sparx, y would the battery need replacing when the system was running fine before i isolated it. obviously the battery has run down but when it is plugged in it still says batt fault?

I have been recently installing a new kitchen and in order to change the current electrics i have had to isolate the downstairs Ring. This has caused my menvier ts700 touchpad to indicate batt fault, re-energising the supply has not cleared this. me and my partner have disconnected the sounder...