Search results

That's what I would like to know ha would make my life easier. This was here when I move in. It's in the way because the dpc is above the floor board level and sticks out a couple of mm so I woul have to rise the level by 30 mm in total to finish above it leaving too much of a step.

It's just below the silicone on the frame. This finishes above the floor level and stick out about 4mm which means I can't butt the floor tiles against it.

Hi is there any reason I can't trim this dpc back flush to the PVC frame? And seal it over with a plastic trim

I removed it to take off the skirting board that went below that board either side. I never intended to tile it. It's was just an after thought. The board that goes there is too thick really to tile on top off will leave a big step. Yeah just a row at the door is all I want

The board had a lip and loads of packing so it wasn't rocking, there wasn't anything wrong with it but we re plastered and had all the skirts changed. The board was always dirty and it hard to clean as we use that door all the time so fancied having a layer of slate tiles there but don't...

Hi I want to replace the wooden board that was at the bottom Of the porch with a row of tiles any advice on how to do this.

Hi I Installed my own texecom last year with the the help of this forum. Today whilst decorating I had to take down one of the pir in the living I entered and enabled engineer turned power of and took it down. The alarm went of so I put the code in. But now it won't let me reset the tamper...

One of them goes of to another room and don't wont to take the carpet up in that room. Think I'm gonna use a junction box ring ring out and spur to new location??

I can see the cable coming from and going to the other sockets. I don't want to run a spur because I want to completely get rid of the old socket (decorating and plastering)

Ps the connection will be under the floor as I've got access via a floorboard

Hi I'm moving a double plus sockets about a metre from where it is now. It's on the ring main it has two cables connected. Both sets of wire are not long enoughwhat would be the best way to extend? Choc box Junction box Thanks

Invaulable this forum!

Why is this no where in the manual I can understand the panel obscurities because its for pros. But the bell box seriously! Ok so I forced the screw through the hole that they didn't fit in with a hammer, might have trouble getting them back out now. Back up with the ladders tomorrow...

I've give up and put as not used. Try again next weekend. I'm going to wore it exactly the same as the window one putting he resistors back in. Another question I just put the bell box up is Oddessey 3e. How hard is it to put the m5 lid screws in. They don't go through the hole probably...

Double eol and entry exit 1?

No it's on the right zone. Zone one on the panel and mapped to zone one on the rkp.

No I've double checked that. It defo say zone 001